With Modal analysis modal models of structures are estimated. From modal models the vibration characteristics (natural frequencies, damping ratios and mode shapes) can be obtained of mechanical structures or component, showing the movement of different parts of the structure under dynamic loading conditions.
Modal analysis plugin is available only in Analyze mode.
Model test is used for measuring excitation and response channels from which FRF results are calculated. Modal analysis is using the FRF results from Modal test to estimate modal models of simple and complex structures. For more information about Modal test take a look at the Modal test manual.
The input into modal analysis module are transfer functions calculated in modal test module
The transfer function can be added with an option Add all TFs. Transfer functions can be separatelly added or removed with Add or Remove button.
When TFs are added, we can see the channel name, excitation node and direction, response node and direction and type of the signal.
Transfer function preview
To see the preview of selected TF enable the Preview option and go to Transfer function preview tab.
Transpose matrix option enables the user to transpone mode shapes matrix. Original matrix show responses is rows and shapes in columns. With transpose option, the modes are displays in columns and responses in rows.
Freqency range selection offers the user to make a modal analysis only in the selected frequency range.
Damping correction should be enabled if a exponential window was used to acquire the data.
Transfer function matrix
The transfer function matrix gives an overview of the set of functions that is set to be Used for modal parameter identification.
The Transpose matrix checkbox should be checked if the response channels are used as reference.
Max order - increasing the order of the estimation will also increase the number of estimated poles. When the estimated poles begin to only change a little between individual neighbor orders, then the poles are said to be stable.
Frequency tolerance - defines the limit for how much neighboring poles must deviate in frequency to be Frequency stable poles.
Damping tolerance - defines the limit for how much neighboring poles must deviate in damping to be stable poles with respect to damping.
CMIF - Complex Mode Indicator Functions (CMIF), have one function for each reference DOF included (poly reference) and can detect closely coupled modes with repeated roots. CMIF is based on Singular Value Decomposition (SVD) of the FRF functions to identify all modes included in the model test measurements. The CMIF functions have peaks at resonances - indicating poles of the DUT.
FRF synthesis - FRF Synthesis is used as a validation tool by comparing the FRFs from the estimated modal model (the synthesized FRFs) with the real measured FRF data.
Mode shapes - outputs the mode shapes for the included modes - based on the estimated modal parameters.
AutoMAC - The Modal Assurance Criterion (MAC) is used to determine the similarity of two mode shapes. “Auto” in AutoMAC means that the two mode shapes comes from the same test.
A Stabilization Diagram (or SD) helps with identifying stable poles and thereby consistent modes. The poles consist of the modal frequency and damping.
Animation of mode shapes
In order to animate a mode, select Mode Shape as a source for animation under Transfer function window.
The Modal Assurance Criterion Analysis (MAC) analysis is used to determine the similarity of two mode shapes:
If the mode shapes are identical (i.e., all points move the same) the MAC will have a value of one or 100%.
If the mode shapes are very different, the MAC value will be close to zero.
When a mode shape is compared to itself, the Modal Assurance Criterion value will be one or 100%.
FRF Synthesis is used as a validation tool by comparing the FRFs from the estimated modal model (the synthesized FRFs) with the real measured FRF data. Hereby it is possible to see how well the estimated model mimics the physical structure’s dynamics.