Analog inĀ 

In Dewesoft we can define and set all analog input channels which will be used during measure using installed measurement hardware.

After adding a new module (Analog in is a default module and must be added only if previously removed), the Analog in the tab on Dewesoft Setup screen can be selected to set all analog input channels and this screen displays two main parts:

  • Dynamic acquisition rate - defines the sample rate of analog, counter and digital channel
  • Channel actions - shortcuts to amplifier commands
  • Analog IN channel list - with information and settings in columns including open Channel setup button.

Analog in_SETUP

Dynamic acquisition rateĀ 

Enter or drop-down and select a sample rate to be used for dynamic acquisition. The maximum sample rate allowable will vary according to which A/D board you have installed, and how many channels are activated for recording. It is important to understand the difference between dynamic and static/reduced rate acquisition. Note that there is a Storing option drop-down list to select different storage options.

When storing dynamically, every sample is stored. This means if you have ten channels activated, and you enter a dynamic acquisition rate of 5000 samples/sec/ch, the resulting data file will contain 5000 samples per second of acquisition for each channel. In other words, every sample point is recorded in the file.

Change sampling rate scaling

Sometimes it is required to change the units for the sampling rate (Hz/ch, kHz/ch, MHz/ch). Simply click on the small arrow below the drop-down list to select another scaling.

Only the synchronous channels are influenced by the dynamic acquisition rate, so raising the sample rate will increase the amount of stored data. The asynchronous channels (like CAN, GPS, …) are not influenced by the sample rate, we only need to take care that the dynamic rate is faster than the rate of data coming from the asynchronous device.

NOTE: Set the sampling rate before you do anything else; this setting will also be used for the setup. This is important to achieve a useful scaling!