After adding a new module (for instructions on how to Add new module see -> Setup -> Add module) the A/D out tab on Dewesoft Ch.setup screen must be selected. When we open a new A/D out module a setup screen will appear, displaying all of possible analog and digital outputs supported by the connected device.
The A/D module is similar to Function generator, we can even use analog outputs.
Control channel setup
By opening the control channel setup we can set:
- General information
- Channel name
- Displayed name of channe
- Displayed units
- Color of channel
- Value type
- If from channel is selected additional settings like Channel, Period and Trigger level must be selected.
- Reset on start measure
- Reset the state of output on start of the measurement.
- Reset on stop measure
- Reset the state of output when the measurement is stopped.
- Output settings
- Use as switch
- Use as digital output