Analog output RT

The AO output RT module enables data transfer of the measured data over AO channels when the OBSIDIAN device is configured in the standalone/RT mode.

All the settings need to be performed inside DewesoftX software

Settings

At the settings you can enable the output functionality and define which input channel should be output on which analog output channel. You can also define the scaling, where “Direct” means 1:1 output, so if input is 5 V then also the output will be 5 V. The other option, “From range”, means that the output range will be matched to the range, so if the input module range is ±100 V and the measured value is 50 V, it will match the input range to the output range of ±10 V and will therefore output 5 V.