Analog/Digital out

After adding a new module (for instructions on how to Add new module see -> Setup -> Add module) the A/D out tab on Dewesoft Ch.setup screen must be selected. When we open a new A/D out module a setup screen will appear, displaying all of possible analog and digital outputs supported by the connected device.

AD out_Grid

The A/D module is similar to Function generator, we can even use analog outputs.

Control channel setup

By opening the control channel setup we can set:

AD out_Control channel setup

  • General information
  • Channel name
  • Displayed name of channe
  • Units
  • Displayed units
  • Color
  • Color of channel
  • Schedule
  • Value type

AD out_Control channel setup_Value type

  • If from channel is selected additional settings like Channel, Period and Trigger level must be selected.
  • Reset on start measure
  • Reset the state of output on start of the measurement.
  • Reset on stop measure
  • Reset the state of output when the measurement is stopped.
  • Output settings
  • Use as switch

AD out_Control channel setup_Output settings_Use as switch

  • Use as digital output

AD out_Control channel setup_Output settings_Use as DO

Analog Out Configurations in DewesoftX online manual

If you require more information on this topic consider reading the Analog Out Configurations in DewesoftX manual