Control channel writer
Control channel writer is a module capable of altering the value of the User inputs channel to a value of a different predefined channel.
NOTE: User input channel limitations apply. The recommended Input speed is below 1Hz.
After Adding the module, you will be able to access it for configuration in Measure mode under Ch. Setup’s Math module by adding Control channel writer.
Input channel and output Control channel are selected in the Input section.
NOTE: Slow changing channels are recommended
The value can be updated by two Update modes. Eather On value change or Periodic where a Time between samples in seconds [s] has to be defined.
The state of control channel at measurement start as well as changes while the measurement is running are set normally in User inputs configuration or with Input control widget.